Anti-mold paint, solution for damp. Complete Kit for 10 M2

HOW TO APPLY: Protect all surfaces that should not be splashed well.

1- CLEANING: With the water-based FK-12 GEL cleaner, free of chlorine and formaldehyde and non-corrosive, the affected area will be cleaned. Apply liberally with a brush and rub the affected area with a brush or sponge. Leave on for 10 minutes. Then remove all traces of dirt with a sponge and clean water, and let it dry completely. If necessary, repeat the operation until the base is no longer detached. It is normal for the base to be left with a dark color, since FK-12 GEL, being a non-oxidizing product, does not produce a deceptive bleaching effect, but on the other hand it is very effective in its task.

2- PRIMER: Apply a generous coat of Disperlith Primer as a bonding bridge and primer, consolidating primer, and BioFilmStop technology that is high resistance to molds and bacteria. The base on which Disperlith Primer is applied must be dry. Apply with a brush or roller a layer to the area previously cleaned with FK-12 GEL. Leave to dry, without rinsing. The estimated drying time indoors is about 3 hours at 20ºC and 60% relative humidity. In the case of heavily contaminated and particularly stained surfaces, after drying Disperlith Primer, it would be advisable to isolate the stain with FK-33 Insulating Spray or FK-16 Base Insulator, allowing the application of the chosen insulator to dry before proceeding to its final painting with Disperlith Industry. Inconsistent bases should also be consolidated with FK-16 or repaired with FK-13 putty before painting with Disperlith Industry.

3- PAINTED: Apply with a brush or 2-coat roller from Disperlith Industry as a final finish. Paint resistant to molds and microorganisms. The estimated drying time between hands, indoors, is about 2 hours at 20ºC and 60% relative humidity. Disperlith Industry can be colored with Mixol pigments at a maximum of 3%.