38,07€ IVA Incluido
Clay dry building board for cladding timber and metal framing constructions of interior walls, cladding of formwork, roofs and roof surfaces. The heavy clay building board brings a lot of clay into the house, with all its positive effects on the indoor climate, especially in thermal terms. It can be cut with a manual circular saw.
For more information about the product, please consult the TECHNICAL SHEET.
As a complement to the product sheet, the CLAYTEC guidelines for environmentally friendly dry building systems apply.
In stock
Scope of application
Application Clay slabs for the cladding of wood and metal constructions in interiors. For interior walls and cladding
DIN 4103-1, installation zone 1 or 2, for roofs and roof surfaces. On surfaces of water exposure class W0-I according to DIN 18534-1, e.g. in bathrooms (except shower areas) and domestic kitchens. For the coating of the entire surface of wood-based and chipboards. With reinforcement layer, holder for YOSIMA Clay Design Plaster or ClayTec Fine Clay Finish Plaster 06 with ready-to-use ClayTec clay paint or the ClayFix clay coating system.
Composition
Clay soil, wood fibres, starch, jute fabric (reverse on one side).
Parameters
Surface hardness ≤ 15 mm,
flexural tensile strength ≥ 0.8 N/mm²,
surface tensile strength ≥ 0.1 N/mm2.
Bulk density class 1.6, bulk density approx. 1,550 kg/m³, thermal conductivity 0.353 W/mK, μ 5/10.
Water vapour adsorption class WS III.
Heat storage: Cp 1.1 kJ/kgK, D22= 35.1 kJ/m²K,
D16 = 25.5 kJ/m²K.
Building material class A2. (DIN 4102-1), A2 - s1 d0 (DIN EN 13501-1) Shrinkage on drying 4%.
Component values
For stability according to DIN 4103-1, the sound insulation of walls and cladding, as well as the building material class and the fire resistance class for walls and ceilings, please refer to the ClayTec guidelines for environmentally friendly clay panels.
Dimensions and weights.
MHK II dimensional accuracy class,
W = 1,250 mm (± 4 mm),
L = 625 mm (± 4 mm),
D = 22 mm/D = 16 mm (+ 1, - 3 mm). Flatness - 1 mm.
D22: Mass approx. 25 kg/slab = approx. 32 kg/m²
D16: Mass approx. 18 kg/slab = approx. 23 kg/m².
Delivery method
Packaged on shrink-wrapped pallets, 09.015 D 16 mm (60 pieces).
Storage
In the warehouse on pallets, dry. Unlimited storage is possible. Protect from moisture during transport and storage on site. Carrying upright with two people
Humidity
Moisture loads from wet installed plasters and screeds are not allowed. In general, the relative humidity during storage and after installation should not exceed 70%.
Material requirements
When determining material requirements, reserves of approximately 10% for waste, etc., should be considered.
If you have any questions regarding application, yield, compatibility, or quantities, please write to us. We will provide a clear and personalized response.
Tell us about your project (type of surface, square meters, interior or exterior, existing substrate…). The more details you provide, the better we can guide you.
At RedVerde, we are here to help you choose with confidence.
Reviews
There are no reviews yet.
Only logged in customers who have purchased this product may leave a review.