Heavy dry partition board 22 mm

Scope of application Clay boards for cladding interior wood and metal structures. For interior walls and cladding according to DIN 4103-1, installation zone 1 or 2, for ceilings and roof surfaces. On surfaces in water exposure class W0-I according to DIN 18534-1, e.g., in bathrooms (excluding shower areas) and domestic kitchens. For cladding the entire surface of wood-based panels and particleboard. With a reinforcing layer, substrate for YOSIMA Clay Design Plaster or ClayTec Fine 06 Clay Finishing Plaster with ready-to-use ClayTec clay paint or the ClayFix clay coating system. Composition Clay earth, wood fibers, starch, jute fabric (reverse side). Parameters Surface hardness ≤ 15 mm, flexural tensile strength ≥ 0.8 N/mm², surface tensile strength ≥ 0.1 N/mm². Apparent density class 1.6, apparent density approx. 1,550 kg/m³, thermal conductivity 0.353 W/mK, μ 5/10. Water vapor adsorption class WS III. Heat storage: Cp 1.1 kJ/kgK, D22= 35.1 kJ/m²K, D16= 25.5 kJ/m²K. Construction material class A2. (DIN 4102-1), A2 - s1 d0 (DIN EN 13501-1) Drying shrinkage 4%. Component Values For stability according to DIN 4103-1, sound insulation of walls and cladding, as well as the building material class and fire resistance class for walls and ceilings, please refer to the ClayTec guidelines for eco-friendly clay panels. Dimensions and Weights Dimensional accuracy class MHK II, W = 1,250 mm (± 4 mm), L = 625 mm (± 4 mm), D = 22 mm/D = 16 mm (+ 1, - 3 mm). Flatness - 1 mm. D22: Mass approx. 25 kg/slab = approx. 32 kg/m² Packaging Packaged on shrink-wrapped pallets, 09.014 D 22 mm (40 units). Storage In the warehouse on pallets, in a dry place. Unlimited storage is possible. Protect from moisture during transport and on-site storage. Transport upright with two people. On-site, store horizontally and evenly on dry pallets or wood. Moisture Moisture loads are not permitted for plasters and screeds installed in a damp environment. In general, the relative humidity during storage and after installation should not exceed 70%. Material Requirements When determining material requirements, allowances of approximately 10% for waste, etc., should be considered.