MORTEX Bipur Matte Varnish

BIPUR-M is a two-component, water-based polyurethane varnish with a matte finish and specific additives, designed primarily for the protection and finishing of MORTEX systems and similar products in interior applications such as floors, walls, countertops, and bathrooms. It is essential to follow the preparation, mixing, and application steps correctly to ensure its effectiveness. Applications:

• Indoor use
• Suitable for floors, walls, countertops, and bathrooms
• Especially suitable for the protection of MORTEX systems and related products

Advantages:

• Easy maintenance
• Transparent and colorless
• Does not yellow over time
• High UV resistance
• High resistance to grease and oils.
• Effective protection against occasional contact with dilute acids and bases, solvents, and gasoline

Formats: 1 kg and 5 kg containers in components A and B.

• 1 kg: A (0.82 kg) + B (0.18 kg)
• 5 kg: A (4.10 kg) + B (0.90 kg)

Storage: Store for up to 10 months in a dry place, protected from frost and direct sunlight. Keep the original container closed and off the ground. Consumption: 90–120 g/m² (in 2 coats) Drying times (at 23°C): Once the two components of the product (A and B) are mixed, there are less than 3 hours to apply it before it begins to harden or become unusable. Wait at least 8 hours and no more than 24 hours before applying the next coat. After 16 hours, the surface can withstand minimal use, such as lightly handling the treated area. After 48 hours, the surface can be used normally, but if the temperature is low (12°C), this time can be extended to 4 days. Complete drying: 5 days. This is when it develops its maximum resistance and can be considered completely hardened and protected. BIPUR Application

1. Substrate and Preparation: The surface must be clean, dry, matte, and free of dust, grease, and weak areas.
2. Mixing Preparation: Filter component A, add component B completely, mix mechanically, and mix again in another container.
3. Application: Apply in 2 coats with a 7 mm microfiber roller. The varnish appears white when applied but lightens as it dries. Check in light before drying to avoid marks.
4. Tool Cleaning: Wash with warm or hot soapy water while the product is still fresh.